Tom Ploppert is a part-time maker from Cullman, AL. He credits his inspiration behind his knife making passion to Bill Ruple - a master at making slip joint folders. Tom built his first slip joint knife in April 2009. He later took a slip joint making class taught by Bill Ruple and Rusty Preston (another Ruple alum). Tom has certainly been a good student. You can see his passion in his work, and tell it from speaking with him. Tom's fit and finish, and attention to detail is obvious once you hold one of his folders. He's also a humble and personable guy. This knife was acquired directly from Tom Ploppert at the 2018 Blade Show. Tom was fortunate to acquire some old, original Westinghouse micarta slabs with rich, buttery yellow color. He made this Dino with those Westinghouse scales, and all I can say is Wow!. This is the finished knife, and Tom knocked this one out of the park! And as that Westinghouse micarta ages and is handled, the color will only get richer and darker, like butterscotch. The Dino is a Ricardo Romano pattern. The blade, as well as the spring are CPM 154 stainless steel. The liners are Integral with the bolster - meaning no seams - making a knife of this construction much more challenging and time consuming to build. The liners are heat treated and tempered 416 stainless steel. The bolster, pins and Federal shield are also 416 SS. The blade has a half stop, locks up tight with no play, and the blade seating is dead center. The blade pivots around an Aluminum Bronze Bushing. Nice large nail nick, with firm pull. Tom's grinds are clean and symmetrical. The tolerances that he is able to maintain are outstanding! Tom has definitely mastered the walk-and-talk, and this knife is a great example. Comes in a padded zippered Ploppert case.
